TCPIP232 Update firmware cable(AVE P/N:021-055-SF)
TCPIP232 Port PC
DB9 Male DB9 Female
Pin-5(GND)--------------------------------------------------Pin-5(GND)
Pin-4(DTR)---------------------------------------------------Pin-4(DTR)
Pin-2(RXD)--------------------------------------------------Pin-3(TXD)
Pin-3(TXD)---------------------------------------------------Pin-2(RXD)
Firmware Update
TCPIP232 is able to update firmware by using software that is supplied to qualified
customers. Contact the factory if this is required.
1. Install Update Firmware Software.
2. Use Update firmware cable (021-055-SF) connect between TCPIP232 and Computer.
2. Select Device from list.
3. Select Device form list and Set option as follows.
Flash Start 0x400000
Flash End 0x480000
Reset wait 250
Default Bank num 0x1
4. Select baud rate 115200 then Open comport.
5. Send Reset command.
6. Erase memory on Bank 40 , 41 and 42 by typing Z40 then press Y to confirm then erase
Bank 41 and 42.
7. Load file Boot System and TCPIP firmware.
TCPIP232 Testing
The TCPIP232 can be tested by using 2 computers in simulate mode.Connect the
equipment same as below.
This connecting diagram has no need to a Hub/Switch just use 1 Cross Over cable
and 1 Straight Through cable and use TCPIP232-PC/DVR Cable(021-037-SF) to program
IP Address same as TCPIP Server software.
1. Install TCPIP Client Tester software to the computer that simulates to be host
2. Install TCPIP Server software to the computer that simulating to be ATM that tapped data
by TCPIP232.
3. Set port Address for listening on TcpipServer(ATM).
4. Use TCPIP Client(Host) to send data to TCPIP Server(ATM) the destination IP address
and port same as TcpipServer configurations then connect and select datadump to
send to TcpipServer on File menu.
PAGE 9
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern