AVE MV DR4000 Bedienerhandbuch

Before trying to connect or operate this product, please read this manual completelyINSTALLATION &OPERATING MANUALDigital Video RecorderMV-DR4000A

8 2.2 Rear View RS-232ALARMDC12VRS-485hi-z75AUDIOININOUTOUTMONITORCH1 CH2 CH3 CH4ETHERNETI/O2531 32 3326 282930 34 35 36 37 VIDEO IN Connector

9 2.3 ALARM In/Out ALARM1 IN ALARM4 INALARM2 IN ALARM3 INALARM OUTRECORD IN GROUNDDISK FULLALARM RESET123456789 THIS FIGURE IS LOOKED FROM THE REAR

103. INSTALLATION Please follow the instructions and the diagram below to set up the system. 3.1 Basic Connection CONNECTING WITH 1 to 4

113.2 Hard-Disk Drive Installation The MV-DR4000 is capable of supporting two hard drives - One internal drive (from factory) and one hot swappable

123.3 System Information and channel selection 3.3.1 SYSTEM INFORMATION You can display system settings information as shown on Figure 3.3 A below

13Figure 3.3 A. Description of Figure 3.3 A (1+2: 59G): Total capacity of installed hard disks, 59 GB (in this example) (12.4 HR): Total 12

143.4 Updating System Software If the system software of the MV-DR4000 needs to be upgraded, please take the following steps to safely update it.

154. BASIC OPERATIONS This section outlines the basic operating instructions for the 4CH DVR. 4.1 Configuring Recording Settings Recording

16 NOTE 1: Recording times on the tables above are estimated. For actual available recording time of a recording configuration, please

174.2 Recording Operations This section details the various recording methods available – Manual, Timer, Alarm, and External. Before commencing with

18 NOTE: If a programmed schedule falls within the current set time of the DVR, recording will begin upon exiting programming. NOTE: If you activate

19 MAIN MENU RECORD ALARM/ MOTION TIMER/ SEQ/ TITLE COMMUNICATION DISK SYSTEM GOTO TIMER/SEQ/TITLE P

204.2.3 Alarm / Motion Recording Take the following steps to activate the programmed alarm recording. For ALM OPERATION, REC RATE, REC QUALITY, AUDI

214.2.4 Externally triggered Recording By connecting the RECORD IN of ALARM I/O on the rear panel of the DVR, you can activate/deactivate the

22 4.3 Playback Operations This section outlines the controls and options available during playback of recorded video. When playing a file, the moni

234.3.2 Slow Forward/ Reverse There are 4 speeds available for a slow playback: 1/2, 1/4, 1/8, 1/16. While playing back recorded video at the reco

244.4 Search Operations This section shows you how to access recorded video. 4.4.1 Full List Search Take the following steps to proceed wi

254.4.2 Alarm list Search Take the following steps to proceed with the alarm-list search function. (1) Press the Search button to enter the s

264.4.4 THUMBNAIL Search Take the following steps to proceed with the thumbnail search function. (1) Press the Search button to enter the search

27 NOTE: If you would like to delete JPG file in the SD card, please return to SD CARD JPG FILE list page and highlight the specific JPG file

1 All the following safety and operated instructions which will prevent harm or damage to the operator and other persons should be read before the un

28 ALARM: Duplicate all the alarm-event recorded video from HD 1 to HD2.  Stay on the DISK SETTING page.  Use the “^” and “v” buttons, and

29 NOTE: If the capacity of HD 2 is not sufficient to store all selected video, a warning message “HD2 SPACE NOT ENOUGH” will be displayed on the scr

302. Archive video of AVI Clips into SD Card Please take the following steps to archive a critical video in a SD card. (1) Insert a SD Card int

314.6 Key Lock Operation The Key lock operation protects the unit against unauthorized use by disabling the entire front panel controls. Press the En

325. MENU SETUP There are 6 categories of operation settings able to be configured from the setup menu. The following sections will provide step-by-

335.1 REC SETTING This page allows you to set the recording rate and recording quality, and enables you to continue recording when the disk is ful

345.2 ALARM / MOTION SETTING This menu allows users to program the configuration of alarm recording only when an alarm input is activated. The device

35 ALM TYPE: This option allows users to set a type of alarm input corresponding to the sensor signal in use. NO: Normally Open. This is to be used

36PRE- ALARM: This option determines whether images that occurred prior to an alarm prior to an alarm activation will be recorded. When an alarm is

375.3 TIMER/ SEQ/ TITLE The DVR provides a weekly table, consisting of two periods of time each day for scheduled recording. This option allows you

2Table Of Contents 1. PRODUCT FEATURES ...4 1.1

38SEQUENCER: This entry allows users to set the DWELL time( time interval) for CH1, CH2, CH3, CH4, and quad view(), the valid values are 01 ~ 99 sec

395.4 COMMUNICATION This option allows you to configure the Ethernet settings when connected to a LAN/WAN as well as RS-232/485 protocols if conne

40NET DHCP: This option selects enable or disable for the DHCP communication function. OFF: Disables it. ON: Enables it. NOTE: If provided with a

41REC RATE: This option determines the recording rate to be recorded at when the FTP function occurs. There are 4 levels of recording rates to choos

425.5 DISK SETTING REFORMAT: This option allows you to clear out all the data in the hard-disk drive. You will be required to enter the pre-set

435.6 SYSTEM This section is used for accessing the history of the operation status, setting the password, resuming factory default, and determining

44BUZZER: This option determines the embedded buzzer sounding a tone to signal the following situations. A tone lasts about two seconds long. ON: En

45 VERSION: This item is in the setup menu reveal network MAC, BIOS version, and software version, and last updated date.

466. RS-232 & RS-485 Protocol 6.1 Setup 6.1.1 Use a Null Modem cable (the standard RS-232 9 Pin Cable with Pin 2 and Pin 3 exchanged, see pin

47 < The value of a specific front panel key > DEC HEX KEY_PLAY 1 01 KEY_STOP 3

36. RS-232 & RS-485 PROTOCOL...46 6.1 Setup...

48 6.2.2.4 Request State (Second Category=0x06) PC Request: <0x41>, <0x01>, <0x20>, <0x02>, <0x06>, <0x00>,

497. IDE Hard Disk Installation Usually, the unit comes with one hard-disk drive installed in compartment HD 1, which is default-configured as a mas

506. 6. Secure the driver in the rack using two mounting screws in both the side-mounting holes. Please don’t tighten the screws too much, otherwis

51 3. Slide the top cover backward and remove. 4. Setting the jumper of your hard disk driver. The way to set the jumper of the drive varies between

52 8. Slide the carrier body back in the mobile rack. 9. Push the carrier body further into the mobile rack until fully inserted. 10. Push the acti

538. System Default MAIN MENU RECORD ALARM/ MOTION TIMER/ SEQ/ TITLE COMMUNICATION DISK SYSTEM GOTO REC PAGE REC SETTING R

54 MAIN MENU RECORD ALARM/ MOTION TIMER/ SEQ/ TITLE COMMUNICATION DISK SYSTEM GOTO COMM PAGE COMM SETTING COMM ID : 01 RS23

559. O.S.D. Message No. O.S.D. Message Meanings 1 NO DISK No hard-disk detected after power up 2 BATTERY LOW Suggest change the battery and reset

5610. Network Viewer and Image Viewer This section provides instructions for installing and using the Network Viewer, and Image Viewer, which are in

57Physical specification for Ethernet Wire Type Cat. 5 Connector Type RJ-45 Max. Cable Length 30 m Hub Wiring Configuration Straight Through PC Wir

41. PRODUCT FEATURES 1.1 Product Introduction The MV-DR4000 four channel Digital Video Recorder (DVR) provides high quality storage of up to f

5810.1.3 View the 4CH DVR video from a remote PC Once Network View is executed a Login prompt will appear, you must enter the default User Name:

59 Functions Description  Device List Displays the entire list of connected devices if and as necessary. This list includes a lot of information ab

60Function Buttons Description Playback function bar.  Play- Click to a recorded video from the PLAY LIST.  Pause- Click to freeze the image

61This allows you to search a recorded video kept in the HDD of the device. Enter the MONTH/DAY/YEAR HOUR: MINUTE you wish to search and click GO to

6210.1.4 Change the Record & Timer Properties Via the Network Follow the instructions below to reconfigure the record and schedule recording set

6310.1.5 Archive Images to the Computer Playback images can be stored in a local PC in the JPEG format. Follow the instructions below to save the vi

6410.2 The Image Viewer This is image integrity-protect software. It not only allows you to view an archived image from the SD card or HDD of a co

6511. Index Table The following description details how the DVR manages an index table issue. The DVR will generate a time index table indicating r

6612. Network Configuration 12.1 Cable Connections Please follow the instructions below to connect your MV-DR4000 to a computer or a network and to

67RJ-45 PIN configuration for LAN Hub PIN NO. PIN Assignment 1. TX + 2. TX - 3. RX + 4. Not Connected 5. Not Connected 6. RX - 7. Not Connected 8.

52. DESCRIPTION OF THE FRONT/REAR VIEW 2.1 Front View A-rec T-recDISK1 223 24Power7Search10Seq./Save16Setup9 11 1413 12Enter15Display818201921

6812.2.2 Enable DHCP Function  Use the “^” and “v” buttons , and , to highlight NET DHCP; select ON. Then press the Enter button to proceed.

69NOTE: When only one unit of the DVR is connected to a computer or LAN, you can freely assign an IP address for the DVR. For example, there are a ra

7012.3 TCP/IP Communication Software Follow the instructions below to install the TCP/IP communication program into your computer.  Click the Star

71 12.4 TCP/IP installation During the installation, you will be requested to insert the windows 98 CD ROM. After installation, the PC will be rest

7212.5 TCP/IP Configuration setting  Click Start  Settings  Control Panel  Network.  Select TCP/IP, and then click Properties.  Before proc

7312.6 Connection Testing With the previous settings, follow the instructions below to ensure whether you have established the connection successful

74 If you receive a response as in the sample screen below, the connection hasn’t been successfully established. Please re-check all the hardware a

7513. Microsoft Internet Explorer This section provides instructions for using the Microsoft Internet Explorer, which are included with the 4CH DV

76Browsing images from the 4CH DVR: The images from the 4CH DVR will be displayed on the home page while going online with the 4CH DVR. There are som

77 Recorded video list box. This box allows you to access all recorded video, which are stored in the HDD of the connected devices. To review a recor

6 POWER button: Press and hold POWER button for 3 seconds to turn on the unit, press (and hold again) to turn the unit off. DISPLAY button: Pr

7813.2 Change Record / Alarm Setting Please follow the steps given below to change the Record / Alarm setting through the network as and when necessa

7913.3 Change Timer Record Setting Please follow the steps below to change the Timer Record setting through the network as and when necessary. 1. Cli

8013.4 Change Pan/Tilt/Zoom Setting Please follow the steps provided below to control the Pan/Tilt/Zoom setting through the network as and when neces

818. The ‘AutoPan’ section has three buttons. The ‘Start’ and ‘End’ buttons fix the two points of any panning movement you select. The third or bo

8214. SPECIFICATIONS Model Number MV-DR4000 Image System NTSC PAL Resolution 720 x 480 pixels / 352 x 240 pixels 720 x 576 pixels / 352 x 288 p

83APPENDIX 1. –SCANIP Follow the instructions below to use the SCANIP software to search the DVR devices from a local location. 1. Click the butt

845. Manual insertion of “Free IP Address”. If you have clicked “No”, please manually type in insertions as required in the “Free IP Address”, “Ga

858. To change any IP address, type in the new address in the “Free IP Address” box on the right as well as the device “Login Name” and “Password” i

7 Jog Dial: The Jog Dial can be used to step frame by frame in the forward or reverse direction. SD CARD Slot: This is used for system softwa