AVE Video Serial Synchronous ATM Interface VSSI-PRO Bedienungsanleitung PDF herunterladen (Seite 24)

Installation

ADPRO FastTrace, Issue 5 1 - 13

Configuring the ADPRO FastTrace via the Ethernet connection is further discussed in the Setup Section (refer to

Section 2.0).

1.10.4 Network Port Pinout

The 8-pin RJ-45 Network port connector pinouts are shown below. Use Category 3, 4 or 5 cable when connecting to

a 10baseT wiring system or network hub. Cat 5 cable must be used for operation on a 100baseT wiring system.

Table 1-3 - Network Port pin outs

1.11 GP Serial Port (1 and 2)

The General Purpose Serial Ports are used to connect the ADPRO FastTrace to other devices that use RS-232

signalling, for example Transaction Devices such as an ATM/POS terminal.

If using the GP Serial Port for ATM/POS, please ensure that confuguration switch 9 is in the correct position prior to

boot-up. Refer to Figure 1-2 for details.

RJ-45 PIN SIGNAL

1 Tx+

2 Tx-

3 Rx+

4 n/c

5 n/c

6 Rx-

7 n/c

8 n/c

NOTE

It is important that a gateway address is only entered if a gateway is present.

ADPRO WEBSITE

For information regarding IP addressing when connecting through a network firewall,

please refer to the Tech Tips page under the literature section on the ADPRO website at:

http://www.adpro.com.au

or contact your nearest ADPRO distributor for a copy.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 91 92

Keine Kommentare

AVE Video Serial Synchronous ATM Interface VSSI-PRO Bedienungsanleitung Seite 24